Key takeaways
- Do not step into the water until you know the power is off. If the panel is downstairs, call BC Hydro or an electrician instead.
- Find the source before you start bailing. A burst pipe, a sewer backup and a failed perimeter drain each need a different first call.
- Photograph everything before you move it. Your insurer will ask, and memory is poor at 2 a.m.
- Sewer water and groundwater are not "wet." They are contaminated, and what they touch mostly has to go.
- Mould can establish within about 48 hours. Drying fast matters more than drying perfectly.
Before you go down there
Water and electricity together are the one thing in this guide that can kill you, so it comes first. If there is any chance the water has reached outlets, baseboard heaters, the furnace, the hot water tank or an extension cord on the floor, do not wade in. BC Hydro's guidance is to shut off the main breaker only if you can reach it from a dry place, and never to enter a flooded basement that may contain energized equipment. If the panel is in the flooded area, phone BC Hydro or a licensed electrician to disconnect the power first.
If you smell gas at any point, leave the house, and call FortisBC's emergency line from outside. Do not flip switches on the way out.
Do not use a household vacuum on standing water. Do not run the furnace or its fan if the water may be contaminated, because you will move whatever is in it through the house. Do not assume the water is clean because it looks clean.
Find where the water came from
In Metro Vancouver houses the source is nearly always one of five things, and each one changes what you do in the next hour.
| What you see | Likely source | First call |
|---|---|---|
| Water rising from a floor drain, tub or basement toilet during heavy rain; smells of sewage | Sewer backup. Older parts of Vancouver still have combined sewers that carry rain and sewage in one pipe. | Stop using water in the house. Call 3-1-1 (City of Vancouver) or your municipality's public works line to check for a blockage on their side. |
| Water along the base of a wall or at a corner, hours after the rain started, clear | Perimeter drain failure or groundwater | Nothing urgent to shut off. Get the water out, then have the drain scoped. |
| Water spraying or running from a fixture, appliance or ceiling regardless of weather | Burst pipe, failed hose or fitting, hot water tank | Close the main water shut-off, usually where the supply enters the house. Then a plumber. |
| Water pouring in at a window well, door sill or stairwell | Surface water: a blocked well drain, grading toward the house, a downspout discharging at the wall | Clear the well and redirect the downspout if you can do it safely. Then grading and drainage. |
| Water dripping through the ceiling from above | A roof leak, a deck ledger or a plumbing leak upstairs | Catch it, contain it, and find the source before the drywall comes down. |
If you have a sump, look at it. A sump full to the brim with the pump silent is a failed pump or a power cut, and a battery-backed pump is the single cheapest thing that prevents this from happening again.
Know your water
The restoration industry grades water into three categories under the IICRC S500 standard, and the grade decides what can be dried and what has to be thrown away.
| Category | Where it comes from | What it means for your basement |
|---|---|---|
| Category 1, clean | A supply pipe, a tank, a tap left running | Most hard materials can be dried and kept if you move fast. |
| Category 2, grey | Washing machine or dishwasher discharge, a sump overflow, clean water that has sat for a day or two | Porous materials that soaked it up usually go. Hard surfaces can be cleaned and disinfected. |
| Category 3, black | Sewer backup, river or overland flood water, anything that came through soil | Drywall, insulation, carpet and underlay, particleboard furniture and soft contents that touched it should be removed. Protective equipment is not optional. |
The catch that surprises people: clean water does not stay clean. Left standing in a basement with dust, cardboard and whatever is under the carpet, it is treated as grey within about 24 to 48 hours. That is one more reason the order of the next steps matters.
Document everything before you touch it
Photos and video of the water level, every affected room, the source if you found it, and each damaged item before it is moved. Open cupboards and photograph what is inside. Keep a running list on your phone of what was there, and hold on to a piece of any material you throw out, a strip of carpet, a chunk of drywall, in a bag in the garage. Insurers ask for proof of what was damaged, and a sample is better than a description.
Then call your insurer, before the cleanup rather than after. Ask three questions: is this loss covered, what is my deductible, and do you have a preferred restoration contractor or can I choose my own. Overland flood and sewer backup are not part of a standard Canadian home policy; they are optional endorsements that many policies do not carry, so the answer to the first question is not always yes. If you are in a strata, call the strata manager as well, since the building's policy and yours interact.
The fans you rent, the dehumidifier you buy, the dump run, the hotel night: emergency mitigation costs are commonly reimbursable when the loss is covered, but only with receipts.
Get the water out
- Protect yourself. Rubber boots, waterproof gloves, and for anything that might be Category 2 or 3, eye protection and an N95 or better. Wash hands before eating or touching your face.
- Move what can be saved. Contents first, up and out. Furniture on legs can go up on blocks or foil if it cannot leave the room.
- Pump or vacuum. A submersible pump for depth, a wet/dry vacuum for the last inch. If there is more than a few centimetres over a large area, a restoration company with truck-mounted extraction will do in an hour what takes a household a day.
- Pull up what is holding water. Carpet and underlay come up. Category 1 carpet can sometimes be dried in place by professionals; underlay almost never is.
- Open the walls if they are wet. Drywall wicks water upward well past the visible line. Cut it out to at least 30 centimetres above the highest wet point, and remove wet insulation behind it. Drywall and batt insulation that took on Category 3 water are not salvageable.
The 48-hour deadline
Health Canada's guidance is direct: a house and its contents are far less likely to grow mould if they are dried within 48 hours. That is the deadline this whole day is really about, and it is why speed beats thoroughness at the start.
- Air movers pointed along wet walls and floors, not at them, so air sweeps the surface.
- A dehumidifier sized for the space, emptied or drained continuously. The target is indoor humidity in the range of 30 to 50 per cent.
- Windows open when the outside air is drier than inside, closed when it is raining, which in a Vancouver winter is most of the time. The dehumidifier does the work then.
- Check hidden spaces: behind baseboards, inside wall cavities, under the stairs, the bottom of the furnace.
- A moisture meter is cheap and tells you when you are actually done, which is usually several days after things feel dry.
One caution about fans: if the water was Category 3, aggressive air movement before the contaminated materials are out will spread it. Remove first, then dry.
Stop mould before it starts
Small areas of mould, under about a square metre, can usually be cleaned by a homeowner with detergent and water, wearing gloves and a mask. Health Canada's guide draws the line for professional help at larger areas, at repeated growth, and at anyone in the house with asthma, allergies or a weakened immune system. If the flood was sewage, do not clean it yourself at all.
What goes and what stays after a contaminated flood:
- Gone: drywall and insulation that got wet, carpet underlay, particleboard and MDF furniture, mattresses and box springs, upholstered furniture, cardboard, paper, soft toys, food that touched the water.
- Can usually be cleaned: solid wood, metal, glass, plastic, concrete, ceramic tile, and hard-surface furniture, washed and disinfected.
- Judgement calls: hardwood flooring, which can sometimes be dried and refinished if it was clean water and you moved fast; appliances, which an electrician or technician should check before power is restored.
Who to call, and in what order
- BC Hydro or an electrician if power cannot be shut off from a dry place.
- 3-1-1 or your municipality if water is coming up through drains or fixtures.
- A plumber if the source is inside the house.
- Your insurer before cleanup begins.
- A restoration company for extraction and drying if the area is large or the water was contaminated.
- A drainage or building envelope contractor once the emergency is over, to find why it happened and stop it happening again. That last one is us.
After the water is gone
A flooded basement that was dried well and rebuilt without finding the cause will flood again, usually the next time it rains the way it did the first time. If the water came from outside, the perimeter drain needs a camera down it, the grading needs a look, and the downspouts need to be traced to where they actually discharge. That is a one-hour visit, and the report from it is worth having whether you do the work or not.
Read how we assess and repair perimeter drains, or book a free assessment.
Sources
- Health Canada, Guide to addressing moisture and mould indoors.
- Health Canada, Flood cleanup: keep in mind indoor air quality.
- Government of Canada, Get Prepared, Floods: what to do?
- Canada Mortgage and Housing Corporation, Cleaning up your house after a flood.
- Insurance Bureau of Canada, Flooding and insurance.
- City of Vancouver, Fix leaks, floods, and sewage problems.
- BC Hydro, Earthquakes, wildfires, and floods: safety.
- Institute of Inspection, Cleaning and Restoration Certification, ANSI/IICRC S500 Standard for Professional Water Damage Restoration.